Counting Pulses from CTR Channel

[yangguotianl]

Can I have the detail procedure to record the pulses counterate from one of the CTR chaneel?

I have R/A pulses from the GR DET, I just have the DET and PreAmp board.
Please show how to configure Warrior to sample these signal with a simple service.

Thanks

[Jerry]

Go to Utilities -> Edit Logging Service Details. Select an existing Gamma service. Click on Service -> Copy. Give a new name to the new service. Click on that service to edit it. Under sensors, set GR=Base, x where x is the ctr channel that you are using.

[yangguotianl]

Thanks Jerry
I figure out I could use Tool STD and Service None to monitor the analogue Channels and CTR channels.
Just copy the none service and modified as following:

Devices:
Device1=BASE,4
Device2=AUX,4

Controls:
I2CInit=21=00,22=00
Scale=36,0

Sensors:
ELTIM=AUX
MINMK=AUX,ELTIM,4
GR1=Base,34
GR2=Base,33
V1=Base,12
V2=Base,13

Tools:
Tool1=STD;serial=Yang

I just copy the STD tool module:standard to a TST module, and then just use the USR software creat my sensors.

Question now:

1.What's the device AUX in the device?

2. What does scale do in Controls?

3. I could record the data from GR1,2 (from my R/A pulse),V1,2 (my low voltage source), what's the sampling rate? or how these are processed in STIP and Warrior by service None?

Regards