I am running a Probe 40Arm Caliper in Warrior and I am trying to Figure out how to do a joint by joint analysis of the log. I am able to go through the log pass and pick my collars with no issue, and scanning the minimal wall for the decimal I can accomplish as well.
I cannot, however, get the % wall loss to calculate, and I also cannot get the data to print out on the log pass.
I was just wondering if anyone else is having trouble with this. I have been through the manual, the online Utilities tutorial (which is the same as the manual), and asked other warrior users. No one has any advice.
I have had the same problem. Jerry Early is looking into it.
Go to Utilities -> Create Variables in a Dataset. Select MinAPIWall and NomAPIWall then click [OK]. Now from Utilities -> Edit Variables in a Dataset, and enter the proper values for the casing.
Once all of this is accomplish, go back to Pipe Tally and rescan the log.