Text only | Text with Images

Warrior System Support Forum

Warrior 7 Software Support => Warrior Software General Support => Topic started by: eldar.rzayev2 on April 02, 2011, 02:08:17 PM

Title: Caliper drift!
Post by: eldar.rzayev2 on April 02, 2011, 02:08:17 PM
PLT XY caliper we calibrated with 4 ring sizes and one in open position. Verification showed ring sizes good.
Then we run in hole and got difference in diameter of casing. Nominal ID of casing 148mm we got on log 158mm. I don't understand why we got like that if calibtation is Ok. Please do you have any idea?
Title: Re: Caliper drift!
Post by: Jerry on April 06, 2011, 11:08:23 AM
I would guess that the tool makes no compensation for temperature drift.
Title: Re: Caliper drift!
Post by: eldar.rzayev2 on April 07, 2011, 04:08:09 AM
If the tool doesn't make compensation for temperature drift, hw can we solve this compensation?
Regards,
Text only | Text with Images