Print Page - Spartek Fullbore spinner, direction calibration

Title: Spartek Fullbore spinner, direction calibration
Post by: cablehead on June 04, 2009, 02:33:23 PM

I am having trouble calibrating the Spartek spinner so that it recognizes negative rotation. (force from above)
Any help would be appreciated.
When I apply air pressure from below, FLOW reads correctly, a positive value, (and comparable with results from Spartek panel/software)
When i apply air pressure from above , FLOW still reads positive value. FDIR stays at 1 for each.
Thanks

Title: Re: Spartek Fullbore spinner, direction calibration
Post by: cablehead on June 04, 2009, 03:08:47 PM

I re loaded the service and now it is working correctly.

Warrior System Support Forum

Warrior Hardware Support => Cased Hole and Open Hole Logging Tools Information => Topic started by: cablehead on June 04, 2009, 02:33:23 PM