Can we record two surface tensions - Loadcell ( conventional) and inline loadpin(as found in Kerr head) in CHIP and Warrior CH. Both tension output to be displayed in log print.
Please share inforamtion on Hardware (chip) and service support, also if any modification requires.
thanks in advance.
I need to make some assumtions here. First that you are bringing the "standard tension" in through the tension 4-20ma input. If the Kerr panel is sending out a 0-5VDC signal, it can be brought in through the AUX1 or AUX4 connector. You would then need a USR tool to process this with an output that is not TENS.