Warrior System Support Forum

Warrior Hardware Support => Warrior Hardware General Support => Topic started by: sahadat on June 21, 2011, 01:00:07 AM

Title: Operating frequency range for STIP?
Post by: sahadat on June 21, 2011, 01:00:07 AM
 I want to know that what is the frequency range for operating the SDS Tool interface panel (STIP)? We have two units one with 110 V with 60 Hz and one with 110 & 220 V with 60 Hz frequency. is there any range or limitation of frequency on the operation of STIP?
Can we operate STIP with 110 or 220 V with 50 Hz Frequency?
and does this frequency change will effect the tool power up operation or data transmission ( telemetry).
Title: Re: Operating frequency range for STIP?
Post by: Jerry on July 01, 2011, 08:25:00 AM
The panels are wired for either 110 VAC or 220 VAC, not for both. 50 to 60 Hz will work on either panel.