Warrior System Support Forum

Warrior 7 Software Support => Warrior Software General Support => Topic started by: mawrick on August 06, 2014, 03:14:54 AM

Title: Tension calibration - possible to add cal points? ? (and is 2 point good enough)
Post by: mawrick on August 06, 2014, 03:14:54 AM
What experience does people have when it comes to the two point calibration of tension that's the default in Warrior ?.

Also I'm wondering if it's possible to add more calibration points to the normal way one does the tension calibration.


For us it seem to be somewhat "off" at times - but I'm not sure if this is due to the 2 point calibration or not.
Title: Re: Tension calibration - possible to add cal points? ? (and is 2 point good enough)
Post by: mawrick on August 11, 2014, 10:05:16 AM
No one have any ideas or thoughts about this ?
Title: Re: Tension calibration - possible to add cal points? ? (and is 2 point good enough)
Post by: alioda on August 09, 2016, 01:46:24 AM
While making your calibration check if the raw value is not saturated at 5v as if so, try to reduce the warrior input voltage from your tension system to 5v or less then two point calibration will be Ok.