Warrior System Support Forum

Warrior 7 Software Support => Warrior Software General Support => Topic started by: mawrick on May 21, 2014, 06:06:57 AM

Title: No specification found for sensor "TEMP2" - PRT can't initialize
Post by: mawrick on May 21, 2014, 06:06:57 AM
I'v added the PRT as a "TEMP#2=ULD,TEMP2,4" in the service editor.

What will cause it to fail this initialisation, TEMP2 is specified as the sensor of PRT.
Title: Re: No specification found for sensor "TEMP2" - PRT can't initialize
Post by: mawrick on May 21, 2014, 08:14:44 AM
Figured out the error. so disregard.