Warrior System Support Forum

Warrior Hardware Support => Warrior Hardware General Support => Topic started by: tong310 on September 30, 2008, 05:06:51 AM

Title: Depth Encoder and Tension signal for STIP (CPF)
Post by: tong310 on September 30, 2008, 05:06:51 AM
Hello,

Could you please advise what type of encoder and tension signal is required for STIP (CPF) ?

-          Which signal does it need for the tension ( eg 0-10 VDC or 4-20 mA)?
-          Which voltage level for the encoder? Is it TTL or HTL or Open Collector?

Please help.

Regards,
Tam
Title: Re: Depth Encoder and Tension signal for STIP (CPF)
Post by: Jerry on September 30, 2008, 08:48:29 AM
The tension input is set up for 4-20ma signal, but with a slight modification to the USB44 board, it will work with a 0-10V signal. The encoder inputs have pull up resistors that feed into a 4050 level translator, so almost any encoder input will work. We recommend the BEI H20EB.
Title: Depth Encoder and Tension signal Connector
Post by: Hamed on February 22, 2018, 02:46:27 AM
Hi, I wan to know the part No, of 7 pin (Encoder) and 5 pin (Tension) connectors.
Can any body help for this?