Warrior System Support Forum

Warrior General Discussion => General Discussion => Topic started by: Mlan on December 18, 2018, 12:44:39 PM

Title: Depth Correcting, using Tie-ins
Post by: Mlan on December 18, 2018, 12:44:39 PM
Hello everyone,

I am trying to use tie-ins for depth correction of a log. This well is 2300 meters , using interactive plot. I was able to linear shift -1.4 m, but i need to correct from 1250 m up.
So I input the measured and actual tie-ins and selected the pass. when I click process a windows comes up asking if i want all the curves added to be corrected so "yes" to that one.
I want to check this correction on interactive plot and nothing happens no correction was done from the Tie-ins.

What step i am missing ? i cant get it to work, only the linear shift on interactive plot worked for me

thanks for the help!