Author Topic: Setting TOPSHOT as depth sensor  (Read 251 times)

crxmaniac

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Setting TOPSHOT as depth sensor
« on: July 08, 2019, 05:44:08 PM »
I am adding TopShot in tooldiagram for perforations services. by adding sensor in service as TOPSHOT=AUX,,4

The sensor output will have a zero value.
I want the sensor output to give TOPSHOT depth.

Any ideas?

regards

rwar

  • Administrator
  • Newbie
  • *****
  • Posts: 9
  • Karma: +0/-0
Re: Setting TOPSHOT as depth sensor
« Reply #1 on: July 10, 2019, 10:36:31 AM »
Are you trying to display the actual measured depth of the top shot on the tool diagram? I don't believe that can be done with the current software.

If you are wanting to show the top shot relative to the tool zero point, you would need to have some tool module use the sensor you added. You might create a zero-length user defined tool for your sensor and carefully add it to the string in the right place.