News:

Welcome to Scientific Data Systems Support Forum!
You are welcome to browse the forum. However, you will need to register in order post or reply topics in this forum. Registration is free and only take 1 minute to complete the registration process.

Main Menu

Depth Encoder and Tension signal for STIP (CPF)

Started by tong310, September 30, 2008, 05:06:51 AM

Previous topic - Next topic

tong310

Hello,

Could you please advise what type of encoder and tension signal is required for STIP (CPF) ?

-          Which signal does it need for the tension ( eg 0-10 VDC or 4-20 mA)?
-          Which voltage level for the encoder? Is it TTL or HTL or Open Collector?

Please help.

Regards,
Tam

Jerry

The tension input is set up for 4-20ma signal, but with a slight modification to the USB44 board, it will work with a 0-10V signal. The encoder inputs have pull up resistors that feed into a 4050 level translator, so almost any encoder input will work. We recommend the BEI H20EB.

Hamed

Hi, I wan to know the part No, of 7 pin (Encoder) and 5 pin (Tension) connectors.
Can any body help for this?