News:

Welcome to Scientific Data Systems Support Forum!
You are welcome to browse the forum. However, you will need to register in order post or reply topics in this forum. Registration is free and only take 1 minute to complete the registration process.

Main Menu

Operating frequency range for STIP?

Started by sahadat, June 21, 2011, 01:00:07 AM

Previous topic - Next topic

sahadat

 I want to know that what is the frequency range for operating the SDS Tool interface panel (STIP)? We have two units one with 110 V with 60 Hz and one with 110 & 220 V with 60 Hz frequency. is there any range or limitation of frequency on the operation of STIP?
Can we operate STIP with 110 or 220 V with 50 Hz Frequency?
and does this frequency change will effect the tool power up operation or data transmission ( telemetry).

Jerry

The panels are wired for either 110 VAC or 220 VAC, not for both. 50 to 60 Hz will work on either panel.