News:

Welcome to Scientific Data Systems Support Forum!
You are welcome to browse the forum. However, you will need to register in order post or reply topics in this forum. Registration is free and only take 1 minute to complete the registration process.

Main Menu

Two surface tensions recording simultenously

Started by m123k2001, February 13, 2011, 03:11:21 PM

Previous topic - Next topic

m123k2001

Can we record two surface tensions - Loadcell ( conventional) and inline loadpin(as found in Kerr head) in CHIP and Warrior CH.  Both tension output to be displayed in log print.

Please share inforamtion on Hardware (chip) and service support, also if any modification requires.

thanks in advance.

Jerry

I need to make some assumtions here. First that you are bringing the "standard tension" in through the tension 4-20ma input. If the Kerr panel is sending out a 0-5VDC signal, it can be brought in through the AUX1 or AUX4 connector. You would then need a USR tool to process this with an output that is not TENS.